Pin thingys in knife handles.

[andy202wr]

OK. How do you make the pins that are in the handles of knifes that I see on the forum. ie. the nice round ones with circles / squares inside them.

[Savagewolfrm]

I have found that if you go to a model shop you can pick up tubes and things and with a little matching and some glue you can arrange some wonderful patterns if you look on YouTube there are some decent videos on how to make it's quite easy but time consuming a a little fiddly. Good luck
Rick

[Thumbcrusher]

Buy them! http://www.thegoodstuffshop.dk/group.asp?group=3128

Great shop this. bought loads of stuff over the last few years and they have always been very helpful. owner speak very good english as well just in case you need to call them!

(No connection to shop - just satisfied customer!)

[Savagewolfrm]

He'll wish I had found this site before I started making mine all that time I could gave saved lolsome great designs nay just have to purchase a few for my handles

[Tony1948]

Hi andy, I get all my brass tube from B&Q ,Use the 1m & the one that is a lot smaller you can fit 4 bits of the small inside the 1m then i put 5 bits ofcopper down the gapes and fill it all up with black apoxy rezin.If you click on my profile then my photos you'll see wot I meen,atb........DONT GET EATEN BY THE BEARS...........TONY

[Tony1948]

Andy click my knife pic then go down to south east meet look at some of my blades I think the last one shows the bits you'll need atb.........TONY

[andy202wr]

Thanks for the replys chaps.

[CanadianMike]

They are known as mosaic pins, and yes, they can be either made relatively easily, or bought (although expensive at times).